CO2Art Bazooka Diffuser

CO2Art Bazooka Diffuser

from 25.99

Small for aquariums below 250L

Large for aquariums over 250L

50mm up to 10 gallon

60mm up to 40 gallon

80mm up to 132 gallon

Small, easy to clean and hard wearing – this is the perfect diffuser for pressurised CO2 injection.

A CO2 Bazooka Diffuser optimizes the CO2 entering the aquarium for efficient plant absorption and less waste. As CO2 bubbles pass through the porous diffuser, they are diffused into streams of tiny bubbles. With increased surface area, the tiny CO2 bubbles are readily dissolved into the water, increasing the saturation of CO2 in the aquarium ecosystem.

To use this CO2 atomizer diffuser, simply connect your CO2 bottle regulator to the atomizer with our CO2 Tubing, and tighten the safety nut.
It is recommended that you set the pressure on your regulator to around 25-30 psi as a starting point.
You should then lower the pressure of the regulator until the pressure is insufficient to force the CO2 through the atomizer, then increase slightly from this level.
The working pressure needed to use with atomizer will vary with regulators.
Please allow a few minutes for sufficient pressure to build up to allow the CO2 to begin passing through; it may not begin instantly.

Add To Cart

This product works well with:

Gift Card

Gift Card

from 25.00
sera flore CO2 active reactor 500 / 1000 sera_reactor_1000.png

sera flore CO2 active reactor 500 / 1000

from 66.99
CO2 Art inline diffuser inline16-22.jpg

CO2 Art inline diffuser

Moss Cotton

Moss Cotton

CO2Art Pro-Elite Series manifold-block.jpg

CO2Art Pro-Elite Series

from 45.99